Author: Gerhard, P.
Paper Title Page
TU2A03 Layout of the New FAIR Post-stripper DTL for Intense Heavy Ion Beams 303
 
  • S. Mickat, X. Du, P. Gerhard, L. Groening, M. Heilmann, M. Kaiser, A. Rubin, V. Srinivasan, W. Sturm
    GSI, Darmstadt, Germany
 
  The new post-stripper DTL at GSI shall accelerate uranium beams with space charge induced tune depressions of up to 37% to 11.4 MeV/u. Emittance dilution must be kept below few percent. However, the layout must also allow for delivery of lightest ions to just 3.0 MeV/u. This broad-banded range of requirements imposes huge challenges on the layout and fabrication especially of the cavities and drift tube magnets.  
slides icon Slides TU2A03 [4.777 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-TU2A03  
About • paper received ※ 12 September 2018      issue date ※ 18 January 2019  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
FR1A05 Development of Pulsed Gas Strippers for Intense Beams of Heavy and Intermediate Mass Ions 982
 
  • P. Gerhard, W.A. Barth, M. Bevcic, Ch.E. Düllmann, L. Groening, K.P. Horn, E. Jäger, J. Khuyagbaatar, J. Krier, M.T. Maier, P. Scharrer, A. Yakushev
    GSI, Darmstadt, Germany
  • W.A. Barth, Ch.E. Düllmann, J. Khuyagbaatar
    HIM, Mainz, Germany
  • Ch.E. Düllmann
    Johannes Gutenberg University Mainz, Institut of Nuclear Chemistry, Mainz, Germany
 
  The GSI UNILAC together with SIS18 will serve as injector for the future FAIR. A modified 1.4~MeV/u gas stripper setup has been developed, aiming at an increased yield into the particular desired charge state. The setup delivers short pulses of high gas density in synchronization with the beam pulse. This provides a higher gas density. Different gases as stripping targets were tested. Measurements with various isotopes and gas densities were conducted to investigate the stripping properties. High intensity beams of 238U4+ were successfully stripped using hydrogen as stripping gas. The stripping efficiency was significantly increased while the beam quality remained suitable. The new stripper setup and major results achieved during the development are presented. Problems with the fast valves arose while they were used for a longer duration. Another revision of the setup took place to exchange the valves. In parallel, the installation of the required infrastructure for regular operation of the gas stripper using hydrogen was planned.  
slides icon Slides FR1A05 [10.013 MB]  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-LINAC2018-FR1A05  
About • paper received ※ 12 September 2018      issue date ※ 18 January 2019  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)